Free embroidery pattern ·
Santa Hat Embroidery Pattern: Free Beginner Christmas Hoop
Free pattern. Beginner friendly. About 1 to 1.5 hours.
How do you make the santa hat embroidery hoop? This free Santa hat embroidery pattern is a beginner hoop: a red backstitched Santa hat whose tip droops over to one side, a grey fur band and pompom where the fabric is the white fur, French-knot fluff, a holly sprig of two lazy-daisy leaves and three French-knot berries, and three gold straight-stitch stars, inside a dotted red ring. Five stitches, four DMC colours, about 1 to 1.5 hours, with a true-size template.
| Finished size | about 4.2 in design in a 6 in (15 cm) hoop |
|---|---|
| Stitches | 5: running, back, straight, detached chain, French knot |
| Threads | 4 DMC colours, 2 strands |
| Fabric | Cream or natural linen, 10 x 10 in |
| Level | Beginner |
| Time | about 1 to 1.5 hours |
| Price | Free |
Printable PDF (free) Save it on Pinterest
What you need
- 10 x 10 in cream or natural linen or linen-cotton
- DMC floss: 321, 414, 699, 729 (one skein each)
- 6 in embroidery hoop and a size 7 embroidery needle
- Water-soluble fabric pen, scissors
How it's made, in short
- Transfer the design. Print the template at 100%, check the 1 in square, and trace it onto the fabric with a water-soluble pen.
- Hoop the fabric. Put the fabric in a 6 in hoop, drum tight.
- Step 1. Stitch the dotted red ring around the design in running stitch.
- Step 2. Backstitch the hat in red in one line: start on the top edge of the band on the left, go up and over the crown and down to the pointed tip on the pompom line (put a stitch end exactly on the tip), then back under the fold and down the right side to the band.
- Step 3. Backstitch the fur band in grey as one long rectangle with clipped corners across the bottom of the hat, using the two holes where the hat ends as band holes; leave the inside unstitched, the fabric is the white fur.
- Step 4. Backstitch the pompom as a small closed grey circle, starting and ending in the tip hole of the hat. Keep the stitches short and on the traced line.
- Step 5. Add seven grey French knots for the fluff: four spaced along the right half of the band and three inside the pompom.
- Step 6. Work the two holly leaves on the left of the band as green detached chains (lazy daisies), one pointing left and one pointing right.
- Step 7. Add three red French knots between the leaves for the holly berries.
- Step 8. Work each of the three stars as six gold straight stitches out from one centre point (18 stitches).
- Finish. Rinse out the pen lines, press, re-hoop and gather the back with a running stitch.
Free guides: Free embroidery patterns · How to do a French knot in embroidery · How to cross stitch · Cross stitch pattern maker
Tips
- Keep the backstitches about 1/8 in long round the crown and the pompom; shorter stitches make smoother curves.
- Stitch the hat before the band, so the band's top edge covers where the hat line starts and ends.
- Wrap the fluff knots twice and keep them loose enough to look soft.
The free pattern
Stitch names follow the common English names; lazy daisy is the same stitch as detached chain.
Size: design about 4.2 x 4.2 in (11 x 11 cm), for a 6 in (15 cm) hoop
Fabric: a 10 x 10 in (25 x 25 cm) square of cream or natural linen or linen-cotton, washed and pressed
Threads: DMC 6-strand embroidery floss, one skein of each colour; use 2 strands throughout. Lengths are the 2-strand thread you stitch with, with spare, cut in 18 in (45 cm) pieces:
- DMC 321 Red: about 54 in (137 cm)
- DMC 414 Dark Steel Gray: about 51 in (130 cm)
- DMC 699 Green: about 7 in (18 cm)
- DMC 729 Medium Old Gold: about 11 in (28 cm)
Notions: 6 in embroidery hoop, size 7 embroidery needle, water-soluble fabric pen or a light pencil, scissors
Stitches: running stitch, backstitch, straight stitch, detached chain (lazy daisy), French knot
Transfer
Print the template page at 100% (actual size) and measure the 1 in scale square; if it is not exactly 1 in, check the print setting. Tape the template to a window, centre the fabric over it and trace the hat, the fur band, the pompom, the fluff dots, the holly leaves and berries, the stars and the ring with the pen.
Put the fabric in the hoop so it is drum tight, with the screw at the top.
Stitch guide
Running stitch: Bring the needle up on the line, go down 1/8 in further along, come up again 1/16 in on, and repeat, so you get even dashes with gaps between them.
Backstitch: Bring the needle up one stitch length along the line, go down at the start of the line, then come up one stitch length ahead of your last stitch and go back down into the end of it, so the stitches touch.
Straight stitch: One single stitch: come up at the inner end of the line and go down at the outer end, keeping the thread smooth and not too tight so it lies flat.
Detached chain: Also called lazy daisy. Come up at the base of the petal, go back down in the same hole leaving a loop, come up at the tip of the petal inside the loop, and go down just outside the loop to tack it in place.
French knot: Come up where the knot goes, wrap the thread twice around the needle, hold the wraps snug with your other hand, and go down right next to where you came up, pulling the thread through slowly.
Order of work
- Stitch the dotted red ring around the design in running stitch. DMC 321, 2 strands.
- Backstitch the hat in red in one line: start on the top edge of the band on the left, go up and over the crown and down to the pointed tip on the pompom line (put a stitch end exactly on the tip), then back under the fold and down the right side to the band. DMC 321, 2 strands.
- Backstitch the fur band in grey as one long rectangle with clipped corners across the bottom of the hat, using the two holes where the hat ends as band holes; leave the inside unstitched, the fabric is the white fur. DMC 414, 2 strands.
- Backstitch the pompom as a small closed grey circle, starting and ending in the tip hole of the hat. Keep the stitches short and on the traced line. DMC 414, 2 strands.
- Add seven grey French knots for the fluff: four spaced along the right half of the band and three inside the pompom. DMC 414, 2 strands.
- Work the two holly leaves on the left of the band as green detached chains (lazy daisies), one pointing left and one pointing right. DMC 699, 2 strands.
- Add three red French knots between the leaves for the holly berries. DMC 321, 2 strands.
- Work each of the three stars as six gold straight stitches out from one centre point (18 stitches). DMC 729, 2 strands.
Finishing
- Rinse the fabric in cool water to remove the pen lines, roll it in a towel and press it face down on a soft towel.
- Put it back in the hoop centred, tighten the screw, and trim the fabric to 1 in outside the hoop.
- Run a running stitch around that edge, pull it up at the back like a drawstring, and tie off.
Counts: 43 running stitch dashes in the ring, 1 backstitched red hat, 1 backstitched grey fur band and 1 grey pompom, 7 grey French-knot fluff dots, 2 lazy-daisy holly leaves, 3 French-knot berries, and 3 stars of 6 straight stitches each (18).
How we checked it: xstitchlib/embroidery.py: 5 stitch names in the dictionary, each explained; 4 DMC threads listed and used; hoop 6 in for the design; scale square; lengths fit one skein each. We work hard to get every number right, but mistakes can still happen; tell us at hello@craftuary.com if anything is off.
Want it on paper?
The printable PDF (US Letter and A4) is free with a Craftuary account.
Get free PDFQuestions
How do you embroider a Santa hat?
Backstitch the hat outline in red in one line from the band up over the drooping tip and back down, then a band across the bottom and a small circle for the pompom in grey, and finish with French-knot fluff, a holly sprig and a few straight-stitch stars.
Do I need to fill the hat with red stitches?
No. The outline carries the shape and the cream fabric shows through, so there are no long fill stitches to keep flat; it suits a first Christmas hoop.
How do you make the fur look white?
Leave the band and the pompom unstitched inside their grey outlines, so the cream fabric reads as the white fur, and add a few grey French knots for texture.
How big is this Santa hat embroidery?
The design is about 4.2 inches across and fits a 6 inch hoop with room around it.
Can I add a name to the band?
Yes. Leave out the four fluff knots on the band, write the name lightly with the fabric pen and backstitch it in red or green with 2 strands.
The pictures are drawn from the pattern's own measurements and stitches; your finished piece will vary a little with your materials.
- Christmas Angel Embroidery Pattern: Free Beginner Hoop
- Christmas Lights Embroidery Pattern: Free Beginner Hoop
- Cardinal Embroidery Pattern Free: Beginner Hoop
- Snow Globe Embroidery Pattern: Free Beginner Hoop
- Free Snowflake Cross Stitch Pattern: Small Christmas Chart
- Christmas Bell Embroidery Design: Free Beginner Hoop
Embroidery and cross stitch patterns: every embroidery pattern on Craftuary.
Embroidery guides: free how-to guides.
Other crafts: Crochet patterns · Sewing patterns · Knitting patterns